Suchergebnisse
Suchergebnisse 1-4 von insgesamt 4.
Hi, have a Highflow Next and Octo - before the recent software version upgrade (I should've paid a bit more attention to this), I used the water temp setting from the HighFlow to control the fan curves on my Octo. After the upgrade, they seem to no longer talk to each other. I tried removing and re-adding the sensor, and while the temperature setting updates properly in Aqua under the HighFlow tab (see top picture), when I add it as a sensor to the Octo, it doesn't show up there. Any thoughts on...
Thanks for the help all - it's not quite super intuitive (how to set this up), but yea, once you figure out that when it displays the canvas (all of your screens at once), then positioning is a lot easier to sort out. Here is my first cut at this, the gauges were pretty easy to set, now need to work on the graphs a bit more..I also ended up sticking with Rainmetere to add the time - I couldn't figure out in Aquasuite how to add the time as a single string, so it was just easier to do it with Rai...
So, loop has been running for about a week, running distilled water + EK Cyrofuel clear. Water quality is ready about 20% and conductivity around 95uS/cm. Is this anything I really need to monitor? Should I expect variations depending on what fluid I use? Am tempted to throw in something like DP Ultra (I need to replace one piece of the loop) just to see if the reading change but anyway, I thought I would ask if / how important these settings are, what should I be targetting / what can I control...
Hi, Just setting up a new sensor panel window, and I was wondering if there was any way to set a specific display size (in my case, I want this to pop up on my second screen which is 1920x480. I tried making the window as small as I could, and also dragging it over to the second screen, but I can't seem to move it to the other screen as well. Any suggestions?