Suchergebnisse
Suchergebnisse 1-15 von insgesamt 15.
Thanks Shoggy and InfoSeeker for the info. I'm running the pumps at 3000RPM with a resulting 1GPM (220LPH) flow so it should be fine. Thanks
I have the following loop: 2 x 360x60mm RAD 1 x 240x40mm RAD Dual D5 pumps in Series 2 x GPU Blocks 1 x CPU Block A total of 1.7L of coolant Would this vacuum pump work for my system for filling and protecting in case of leaks? Thanks
Like this: [attach]6852[/attach]
I completely agree with what you said. Regarding the pump, I basically did the same thing (except I have dual D5 G2). I found the most silent speed and checked to see if the flow is between those values. 1GPM at 86% PWM. My pump resonate differently, but are silent at 86 and 95%. At 95%, though, they increase the water temps by about 1-2C so I stayed at 74%. Also, I found that the D5 pumps perform exponentially better at higher speeds (eg. 86% - 1GPM, 100% - 1.7GPM). Regarding the setup and outp...
The reason you are experiencing this is because the minimum PWM value for the pump is set to 0%. Usually the pump works in full speed when the PWM is set to 0%. To counteract this, go to FANS, and set the minimum PWM value for the Pump output to, lets say, 30% and check Keep minimum value (or something). This way the Pump will be at 30% while the PID Controller is at 0%. Another thing, as InfoSeeker stated, is that it is better to set the pump at speed that gets you 0.6-1 GPM. There is no reason...
When on aquabus you control the outputs using the controllers (including curve) from the AQ6 tab. The Quadro fan outputs are automatically mapped to fan 5 through 8 in AQ6.
Like I mentioned yesterday, once you disconnect the USB link from the Quadro, you lose it's tab in Aquasuite and have to control the fan outputs through AQ6 as usual (no RGBpx or anything except fans through AQ6). The picture above was taken with the USB and aquabus links bith connected.
So, I disconnected the USB cable and the Quadro disappeared from aquasuite. In this case only the fan outputs can be controlled through AQ6 only.
I will test it but don't know if I can today. Will report back.
I have it on both USB and aquabus and fan control is impossible through Quadro tab. It seems that only start boost setting affects it (seems to be a bug), but otherwise you can use the curves in Quadro AQ6 while it's connected through aquabus.
Doesn't seem to add an extra curve controller to the AQ6. You are still limited to 4. Another thing is that once you connect it through aquabus to the AQ6, you lose control over the fan outputs through the Quadro and can only control them through AQ6.
Zitat von »GTXJackBauer« Awesome. Are there options for dual D5 pump configuration with a tube/cylinder reservoir? +1
Is this true also for aquaero 6 LT?