Fantastic Firmware update! this is leaps and bounds above Beta14!! My display is finally working again. (The water flow kept jilting the screen out of sync) and the additional information pages has been long awaited. I have one small problem however, when trying to access the software sensor data source. I get the following error. http://img526.imageshack.us/img526/9636/…twaresensor.jpg I have checked the service which has started correctly, and AIDA64 WMI has been enabled. I did use Alpha 2 pri...

A bug with beta 12 (not tried 13 yet) is the max fan speeds reset to 100% when clicking on the fan in aquasuite 2012.

Happens to me all the time with the corsair 800 D after taking it out or disconnecting the water block when changing my loop. I don't believe it's the grounding since it only happens when the far side of the brackets are bent to fit in the bay slot. To fix it I do the following steps with the computer off: Unplug the USB With the Allen key loosen all the screws and push the brackets in as far as they will go and move the screen cover around. All the time replugging the USB cable back in and unpl...

Any chance on adding information pages to cover fans 5-10? Or even better, allow custom information pages to allow for example fans 1,3,5,8 or temp sensors 1.4,8,10 to be on the same information page? Thanks

http://forums.vr-zone.com/uvnium/1010363…ts-here-15.html You can see pics at the bottom. I use OC2010 as my username. Any suggestions would be appreciated. Thanks

That's funny as my Ac high flow also reads 150 lh, which I'm worried about being too low also. Only using one D5 though

Yep did that many times, also updated my drivers. Pity I don't have another computer to test it on, but the aquaero 5 and 3 PAs were all detected.

Connection wise must be correct. The fact that it recognizes there is a USB device, but fails to install it, suggests I got a faulty Tube meter. How do I go about getting a replacement as they're not cheap! Thanks

Everything is working fine with Beta 11, except the Alarm control crashes when I try to access the page.

Hi, I have hooked my Tubemeter to the PC via the PC USB cable, and continually receiving a message saying the device failed to install. Device settings show the device as an "unknown device" Further more when connected I see no LED turning on via the tubemeter. Is there a driver I can use to install this as Aquasuite 4.72 does not pick the tubemeter up either. Thanks