• 18.10.2019, 20:38
  • Register
  • Login
  • You are not logged in.

 

Search results

Search results 1-6 of 6.

Friday, November 30th 2018, 7:50am

Author: Mazdabater

Aquasuite overview page on desktop

Hey guys, I run 3 monitors for my computer, I like having my overview page on the desktop but it always locks to the left screen, I can't seem to find a way to move it. I would love to have this on my right monitor, is this at all possible to setup?

Tuesday, August 14th 2018, 12:30pm

Author: Mazdabater

High flow usb sensor not reading flow rate

So it seems that I've been given a faulty one then? Has anyone delt with aquacomputer for warranty? Seems like it would just be easier to take the hit and buy a new one

Friday, July 27th 2018, 11:09pm

Author: Mazdabater

High flow usb sensor not reading flow rate

The glow sensor was only just added so it was never hooked up to the other psu. I did blow through it and didn’t hear anything moving so I guess my curse continues and I have another dodgy part.

Friday, July 27th 2018, 8:10am

Author: Mazdabater

High flow usb sensor not reading flow rate

It's definetly the high flow usb and not an MPS one. Current loop has 2 x 480mm rads 1 x 420mm rad 2 x EK D5 pumps 1 x cpu block 1 x motherboard block (on Maximus X Formula) 1 x gpu block It will have another cpu block and possibly a gpu block in the loop when I get my mini ITX system back from RMA

Thursday, July 26th 2018, 12:59pm

Author: Mazdabater

Corsair 1000D case

I wasn't going to show off my case at all since I have had some RMA issues with my mini itx system (not one but 2 faulty be quiet sfx-l 650w power supplys killed 2 motherboards. And the PC shop is trying to blame me for the motherboards), but I made a bracket up to house my aqua computer if your looking for some ideas. I figured putting it below the radiator would give it a bit of air flow at the least.

Thursday, July 26th 2018, 12:15pm

Author: Mazdabater

High flow usb sensor not reading flow rate

Hey guys, I finally got around to installing my flow meter last night. I have upgraded it to the latest firmware and it's reading the water temp internally but the flow rate is stuck on 0. Is there something I could be missing here? The only thing connected to it is the USB connection from the mobo.