Suchergebnisse
Suchergebnisse 1-6 von insgesamt 6.
Replacing the diode has not helped. Died controller ((( The controller has been filled with resin. Had some work to clean it. The question now is - if I changed to a working chip (ATMEL), will need special firmware or will be enough this - aquastream XT-Firmware 1.09, DIY-Flasher?
I ordered a new diode - it will be soon to come. After replacing the diode, I will inform the result of repair
Sven - thank you for additional information, I hope it will help
Thanks, I'll try to replace the diode itself. Are transferred to other countries are very far (and expensive).
Confronted with an issue. Improperly connected cable USB pulling the +5 V is on the other connector (Pin 4 D-). Then, of course, ceased to operate the software. I want to ask - my pump is beyond repair or electronics will not recover? I lifted the hood and checked all the diodes. This diode was burned. Unfortunately, I do not know what the face value can be replaced. Here is his picture: Please forgive me for my English - it is not my native language. I look forward to a reply.