Suchergebnisse
Suchergebnisse 1-4 von insgesamt 4.
never mind 1.) Turn off the PC and remove the standby power if you are using it. 2.) Remove all sensors from the aquaero. 3.) Place four jumpers on the temperature sensor connectors 5 to 8. 4.) Power on the system and after a few seconds you should see a recovery mode screen in the aquaero display. 6.) Turn the PC off and remove the jumpers from the aquaero. 7.) Start the PC and use the latest aquasuite 2012 software to flash the firmware onto the aquaero. It should perform a restart afterwards ...
Yes can someone clarify this please!
I have the same problem.... Anyone got a fix for this?
Had the same problem...Im useing win7 ult 64bit and I turned off UAC in user profile setting and then ran aqua 2012 as admin...now everthing works. I hope this helps you. Jays_sho