Suchergebnisse
Suchergebnisse 1-10 von insgesamt 10.
thought i would do an update on the aquasuite software so installed beta 14 version done a firmware update and now fan 3 and fan 2 are down overview page is just all yellow triangles, looks like the software isnt able to support the hardware
overview page shows no rpm yet fan still spins fan controller page allows me to alter the rpm of the fan the controller page shows the setup of all the fans (fans 1, 2 and 4 working with no issue, fan 3 working but with no display on the overview page
if the diode is faulty would the following still be able to occur, when in aquasuite 2012 beta 13 i can go to the fan section select fan 3 go to advanced settings set the rpm down to say 50% and you can hear the fan slowing down to the selected speed, the fan header is functionioning properly just not getting any display thru aquasuite 2012
probably cheaper just to buy a power adjust 2 since the rest of the unit is working correctly, as far as damage is concerned unit was connected up correct as per instruction manual so what else would cause this to occur
done continuity test and im getting continuity across pins 1+3 so how do i go about getting it repaired
checked fan in other fan headers and shows up rpms is there anyway to test the unit to see if its faulty and do you know what kind of warranty these units have
when in aquasuite 2012 beta 13 firmware 1022 under aquaero 5 fans section have all 4 fans displayed along the top fans 1, 2 & 4 show rotation speed and the voltage functioning correctly fan 3 however show rotation speed at 0 rpm and a voltage of 11.8v. when i go into the settings for fan 3 i can move the sliders and you can see the fan speed up and slow down accordingly but get no rpms from it. ANy ideas
im having similiar issues, got the aquaero 5 lt running aquasuite 2012 beta14 fan 3 is reading 100% with zero revolutions yet ive got a fan attached to it, if i go into the fans i can adjust fan speed voltage etc and it slows the fan down accordingly just no display of it in the display page and ideas please as its pretty frustating.
got an aquaero 5 lt want to setup the led warning system from it, what i want to know is can i daisychain 4 of the dual red/blue leds together and run from the led connector on the aquaero 5 board or would it be to much drain from the board as it states lmax 20mA U 3-4V leds im using are 3.5v Blue 2v Red 20mA.