I installed the new version, but can't seem to update the firmware! it seems to be just hanging in the last bit.

Zitat von »mandrix« That seems like a pretty low flow number. I haven't hooked any D5's to a flow sensor though, I'm using a MCP35x. I have all 7/16" ID tubing, guessing 4-5 foot 2xUT60 480mm rads in pedestal (hence the amount of tubing) cpu block 2xgpu blocks 6x 45's & 3x90"s & 1x5 way "snake" (all rotaries except the drain line) 169 calibration setting for the high flow sensor my max flow is around 1.2-1.3 gpm. Just based on past experience with D5's I would think you would get more than 0.4g...

Hi I got an Aqua Computer High-Flow Flow Sensor connected to my loop and I think the flow is too low! I have set the calibration value of the flow meter to 159 as I have seen in an article in XS forums. It is showing the flow as 0.4 gal/min even at setting 5 of the D5 pump! which I think is too low for a loop like mine My loop consists of Koolance CPU 370 1.1 block Koolance HD6970 Full cover block 1 x 480mm Alphacool XT RAD less than 1 meter of 1/2" ID 3/4" OD tubing 1 x D5 pump 2 x Koolance QDC...

I have an AQ5LT unit that was working fine till today. My case fans (4 x Arctic F12 fans) were not spinning so I had to see what it was. I connected 3 of the same fans(F12) to all the headers except the one which says D5 pump(techo signal only) and the RPMs and Amps were very different on one of the headers. Turns out that one of the fan headers("case fans") is getting lot of current(1.97A)! All the headers are at 100%. Uploaded with ImageShack.us Is it RMA time