I used to get a hard lockup, then i changed usb ports i was using a aquero 5 xt and lt on the same ports on the mother board i then swapped them around and no more lockups

Thanks for the info If i have the Lt set as slave i lose 4 curve controllers from when it was set as a master LT also im having a big problem with aquasuite if i disable a software sensor it shuts down my pc and aquasuits just randomly locks up the pc, seems to only happen if i have the Lt and XT as master maybe its something to do with the usb there on the same bus

I have the Aquaero 5 xt and the LT at first i hadfe the LT as a slave device connected to the XT i wanted more than 4 curve controllers initially is it ok to run the LT in its default state through the usb and without the aquabus connected Will the set point controller do the same thing as the curve but with less control.