Suchergebnisse
Suchergebnisse 1-9 von insgesamt 9.
It is probably dead. I have same probelm wiht my new high flow USB. It was working good only one day . Tomorrow it was dead.
This is bug in the firmware. Should be fixed with the next release.
I received a response from aquacompuer about frontplate : "Yes. The front is glued.You should use a flat screwdriver or knife and start at one corner and carefully split away the front step by step." But my advice is to use vCard, or some plastic knife for paper
This is not a compatibility problem The question is how to remove default frontplate
I have same problem seems to be that default mask is glued with pcb.
It was hardware issue. It is fixed by aquacomputer
When I want to change srcreen form LCD page to another , I get double page in same time. It is look like that aquaero have some problem to shutdown lcd page. There is no problem when changing form another page to LCD page. Is this hardware or software issue.
Hi, I have aquacomputer high flow meter usb. After a day of work, I stopped to get flow-information. I also noticed irregularities in the readings of water temperature. It is quite slow to react to changes and gave the incorrect temperature +-1.2c. I compared with three thermometers ..... I reinstalled netframework 4.5.1 , and aquasuite... What to do ? Best Regards Delevic