The email with the screen captures has been sent. There is only one fan on each channel. All 4 fans are BitFenix Spectre Pro LED 230mm. There is a link for the fans in the email. If you need any more screen captures, just let me know.

I'll start working on that now. Would it be easier if I were to email all of the .jpgs to you rather than posting them all in this thread? And thank you very much for your prompt responses.

Test 1 Controller 1 Power Slider 100% Fan 1 : 914 rpm, 12.0V 100% Fan 2 : 920 rpm, 12.0V 100% Controller 2 Power Slider 50% Fan 3 : 920 rpm, 11.8V 67% Fan 4 : 910 rpm, 11.8V 67% Test 2 Controller 1 Power Slider 0% Fan 1 : 700 rpm, 7.9V 0% Fan 2 : 695 rpm, 7.9V 0% Controller 2 Power Slider 50% Fan 3 : 705 rpm, 8.0V 50% Fan 4 : 695 rpm, 8.0V 50%

Ok, so I turned off the computer, disconnected all the fans/pump, waited a couple minutes and turned it back on. It passed the tests, 12V @ 100%, 8.1V @ 50%. I turned the computer off and reconnected everything. Bring it back up and now it is behaving the same way as before, adjusting the fan slider makes no change in fan operation. I then disconnected my pump and attached it to the motherboard and then moved the MB fan over to output 4. When I brought it back up now the fans will change speed w...

I did the reset as you suggested. After the reset, the first thing i did was create a new controller and assign fan 4 to this controller, I also set the fan 4 option to PWM. This one is controlling my pump and I really don't want it turning off. I then moved the slider to 50%, there was no change in fan RPM. I then moved the slider to 0%, still the fans spun at full RPM. To be sure, I did another factory reset and this time left everything alone (Pump included) and moved the slider down to 0%. A...

I just got my 5LT and installed it in my computer. I am having trouble getting the fans connected to the controller to do what I program. Setup: Aquaero 5LT 3x BitFenix 230mm fans I created a virtual sensor based on my ambient air temp and my radiator output water temp. The sensor reads exactly what it should. I went into aquaero>Fans> and on each fan I set the minimum power to 0%, 0V and the maximum power to 100% 12V. "Hold minimum power" is NOT checked. Advanced settings are left at "Power Con...