Sure rampage v extreme board ek combo cpu/mobo 4x Titan X Hydrocopper, connected with crystal link bitspower fittings bitspower dual d5 top 1 koolance quick disconnect in back EK tube res 2 x http://www.performance-pcs.com/aquacompu…-interface.html 2 x XSPC 480 rads http://www.xs-pc.com/radiators-rx-series…fan-radiator-v2 Flow meter - http://shop.aquacomputer.de/product_info…roducts_id=2294

Just to avoid any confusion with the US and the silly system of units we insist on using, I'm getting 1 L/m. Is that ok? Thanks! Tommy

This one: http://shop.aquacomputer.de/product_info…roducts_id=2294 According to what I'm pulling up on the aquaero, the pumps are set for max power. With both of them set for max power, I get .2 - .3 GPM. So I'm at a bit of a loss. I do have a couple more D5 pumps and poweradjusts so I could hook them up but of course that means draining and if it's only going to get it to .6 at max it seems like a waste.

Ok so it appears they're both at 100%. So I guess I have a flow issue. I did verify the pulses/liter were set correctly on the high flow flow sensor. My loop is 2 aquacomputer d5 pumps with (usb/aquabus) -> High flow sensor - > 480 rad -> 480 rad -> EK full cover waterblock (CPU and Mobo) -> 4 gfx cards in parallel -> tube res-> pumps. Do I have the correct number of pumps for something like this? Thanks Tommy

I haven't hooked them to the motherboard via usb because the motherboard isn't being powered atm. I ended up using a three pin fan cable to one of them and was able to see it. So I guess I need to set that up afterward. I have 4 gpus in parallel in my loop so perhaps that is why my flow is so low? I was hoping 2 D5 pumps would be enough.

Hello I have an aquaero 6. I have it connected to a Y aquabus cable which is connected into the back of 2 D5 aquero pumps with the usb/aquabus interface. If I click Pumps on Output, I don't see any information. I also have a aquero flow sensor hooked to the aquaero which does seem to be working correctly. Basically I just want to make sure the pumps are running 100% to see if I have enough flow. How can I get information about the pumps on the aquaero 6? I'm currently seeing a flow of .3 gal / m...