Zitat von »Bartdude« Hmm I was quite excited about a new firmware release until I read through this thread think I'll leave updating till it's been fixed I know the feeling... though I'm still not 100% sure if this is a bug or problem with the software. Maybe my hardware is faulty. Still waiting if Sebastian or any experienced user (I'm a complete noob) can pull a rabbit out of the hat

Zitat von »sebastian« Zitat von »StephanWeber« Again, I've tried with both pumps connected, and each individually as well. I've changed the usb cables and made new 4 pin 1 to 1 cables to connect on the high flow, also didn't work. Did you see the the mps pump device when you connect only one pump via aquabus? After firmware update have you power off your system complety - no standby voltages, power supply cable unpugged for more than 20 seconds? No. The pumps are never shown as aquabus devices ...

Zitat von »Dundys« Please, if possible consider making option of going back to older firmware and ability of undoing buggy software changes Agree! Is there any chance I can get previous firmware/aquasuite version to test my devices?? Still not working here. Spent the day rebuilding cables, changing connectors, shutting down, reset, rinse and repeat I've noted another weird behavior under the aquaero tab: The "Update firmware now" (aquaero > system > Firmware update) is always enabled - see atta...

Zitat von »sebastian« are your 2 mps pumps listet as mps under aquabus tab? Reset your 2 mps to factory defaults, switch the device type (system tab) to a other device and switch it back. Select the bus address. Save the settings (disk symbol). When everything is correct you see the both pumps in the aquaero tab and see the mps devices in the aquabus tab. The pumps are not listed under the aquabus tab. I've tried your solution, didn't work. Again, I've tried with both pumps connected, and each ...

Zitat von »InfoSeeker« So you see the two pumps in the aquasuite tabs, but you do not see the pumps in the pumps tab under the aquaero? A screenshot may be helpful. Exactly! Both pumps are available as mps, but under the aquaero "Pumps" it's empty. Screenshots attached, and thanks for the reply!

Still not working... All firmware is updated (usb connection for both pumps works fine). I've tried all the following for the aquabus connection: - Connect both pumps (using a splitter. Pump 1 on address 12, pump 2 on 13); - Connect pump 1 with single cable - Connect pump 2 with single cable Using different cables, always shutting down the computer and disconnecting the PSU. Really need help, guys! Any thoughts??

Hi Sebastian, Thank you for such a quick reply! I'm aware that when you connect the devices on the aquaero they are controlled by the "aquaero" menu on the aquasuite and the usb mps settings will become obsolete. My problem is: I can't set the priority to aquabus, as I've seen on several videos/tutorials/documentation. There are no radio buttons "( ) Set priority to USB" and "( ) Set priority to Aquabus" on the mps settings. Since this is a new version, has this feature changed? Also, I've reset...

Hi Shoggy, I am about to finish a new rig, and got to the point of filling my loops and configuring them. This is the first time I'm doing water cooling, and therefore the first time I'm dealing with Aquacomputer products. I have two loops with D5 pumps connected to an Aquaero 6 XT. I've read in several forums and documentation that first thing to do (for aquabus pumps) is to fill the loop, connect the pump via USB, install aquasuite and set the priority to Aquabus. Did all that, aquasuite recog...