Suchergebnisse
Suchergebnisse 1-11 von insgesamt 11.
Zitat von »Hufeisen« You dont need a Splitty4 if you want to change RGBpx Connector to ASUS Connector. This https://shop.aquacomputer.de/product_inf…roducts_id=3829 is enough. You need to buy a RGBpx Cable to connect the Adapter to the RGBpx Port on the Quadro, D5 Next or Farbwerk 360 https://shop.aquacomputer.de/product_inf…roducts_id=3763 Oh, I see, didn't notice that thingy. Thanks!
Hey everyone, splitty 4 has a regular 5V RGB header (named ASUS on the board), so do I get it right - if I plug regular addressable RGB strip to it I can get the RGBpx effects on it? Or do I need anything else? I have both Farbwerk 360 and D5 NEXT. Manual says only about Corsair and NZXT and nothing about that ASUS header. Thanks in advance.
Zitat von »Shoggy« It's a known USB problem and should be fixed with aquasuite 2018 (~2 weeks). Thanks!
Strange pump) Anyway, I think flow rate is just not enough at 2000RPM to be measured by flow 400.
I believe you can do it with Aquasuite (if it's connected to Aquaero) switching it to "Power controlled".
Try to run the pump at 3000 RPM and check what happens.
Here's the video. https://www.youtube.com/watch?v=zimtNfSVbH0
What kind of pump do you have and what speed it runs at? How many waterblocks/rads/angled adapters? Flow 400 only detects rates from 80 l/h, if your flow is below that you will always get 0.
Hi, I have a problem since the 1st day I bought Vision/Aquaero setup. Maybe some people experienced the same. I have: Kryos NEXT VISION CPU block VISION for GPU block MPS flow 400 Aquaero 5 Pro HUBBY 7 So, HUBBY 7 is connected to motherboard's USB 2.0, all other USB devices plugged into HUBBY. Flow 400 connected to HUBBY and to Aquaero by Aquabus to HIGH (actually the connection of mps doesn't matter, I tried all combinations and even without mps). Aquaero is configured to read the sensor inform...
Works after reboot. Strange.
Hello everyone, I need your help with the following - I have an Vision waterblock, in Aquasuite I add the display that shows 4 rows of text (temperatures, etc), I can modify the name of the sensor but when I add the sensor from Aquacomputer monitoring (CPU, GPU, etc) - no temperatures are shown on a display, just the names. Or do I need an Aquaero to enable this? Any help appreciated, thanks.
16.04.2024, 15:32
Sprache ändern
Registrieren
Anmelden
