Suchergebnisse
Suchergebnisse 1-6 von insgesamt 6.
I have connected both quadros to USB headers and assigned different addresses. I can get them to work though the USB port with a fan curve for temperature of the water, and the flow sensor works as well. Once I connect them to the Aquero with the aquabus x4 nothing works, and the Aquero does not show anything on the screen like it is not getting power. Once I remove the aquabus cables from the X4, the aquero shows stuff on the screen again. Not sure where to go from here.. Thanks
Hello everyone, I am having issues running dual loops on my 6 pro, my current setup is below. PRO 6 2 x Quadros 2 x Flow sensor high flow LT I saw that the PRO 6 can support up to two Quadros, but I can't figure out where to plug them into the PRO. The Quadro's did not come with aquabus wires from what I can tell, so I know I will have to buy two extra wires. Would getting the expansion module help in reading both loops independently? If I hooked one up to a USB on the Motherboard and the other ...
I am having issues with a few things, and hopefully I can get some help. 1. My sensors for CPU and GPU are crazy off.. I am doing intelburn in test and running 70+ degrees and my cpu sensor is telling me 32.2, so setting a fan curve right now is impossible. My GPU sensor is off big time as well! 2. I have 2 PWM pumps installed into the aquero, and 0 pumps show up, so I can not control them. Am I missing where to connect the pumps to actually allow me to control them through the software? Thank y...
Zitat von »Shoggy« Try this. Thank you very much! was able to get it going!
Brand new build.. Pro 6 USB connected to header.. I get USB not recognized and fails to go any further. I then go into device manager find the yellow triangle and try to update manually, but nothing works. Rather disappointed is this a common issue, or am I just lucky?