I had to replace a bad D5 aquabus board and I was told that the AquaComputer D5 pump will be discontinued. Not sure why.

Unfortunately, I tried that and it's still not detected.

Hi, I just installed an new aquaero 6, MPS 400 flow sensor, and a Aquabus D5 pump. I connected each device to aquasuite and have upgraded all the firmware and set the aquabus bus address. I set the MPS sensor to address 12, and the aquabus D5 pump to 13. I have also tried other addresses for the pump, but still not successful. I can detect and control the D5 pump via USB through aquasuite, but cannot get it detected in the aquaero 6 via aquabus. The MPS flow sensor is detected and working correc...