Suchergebnisse
Suchergebnisse 1-7 von insgesamt 7.
Aquacomputer support quickly responded thinks I have faiulty device will need to send in.
I just sent them an email last night I will wait for a reply. Thanks for the help @InfoSeeker. At this point im really thinking its a faulty Aquero. With all RGB outputs set to 0% I still get a 4.4v readout across the ground pin and blue led pin on the Aquaero. Do you have an Aquaero and could confirm that no LED should be lit when all RGB outputs set to 0%?
So I swapped the Red and Blue wires on the PWM connector and issues followed the Red LED where brightness increase actually decreases brightness of RED LED. I did remove heat shrink from LED side of the RGB and notice there was bare wires exposed and they could have been touching each other. Do you think this could causes some sort of damage to the Aquaero?
If I set all channels of the RGB to 0% the blue led still remains lit
Correct using this one https://shop.aquacomputer.de/product_inf…roducts_id=2664 connected to Aquaero 6 RGB header
Here you are a screenshot https://imgur.com/K6CzCkz With those settings the LED is a very dim blue at 100%
When the aquacomputer RGB is connected to the Aquaero 6 LT for whatever reason when I have all three channels set to 0% the RGB is blue. Additionally with I just increase the blue channel brightness the LED begins to go a dimmer blue. It seems as though the red and green channels are working but with the blue LED always illuminated, despite aquasuite saying its getting 0% power, it messes with the rest of the colors when trying to pick them. How can I fix this? I tried to "update firmware" of th...