Suchergebnisse
Suchergebnisse 1-12 von insgesamt 12.
Zitat von »zouille« Zitat von »Revan654« Zitat It's not a voltage issue, the Hubby lights up fine, other devices work fine. It's not a pin orientation or misalignment issue. I tested the Hubby in both SATA and USB mode. I referred to both the motherboard manual and the Aquaero manual before I plugged any USB cable in, and visually checked the pins too. I tested the Aquaero on every single position on the Hubby 7 but Aquasuite just would not detect it. Try the Cable on ROG EXT header as well. Is...
Oh and i forgot, hubby7 work fine with evry on AQ devices when i plug hub to may very old laptop. Its ridiculous.
I do IT the same. I do not hawe problem with not working hubby7 it just not work with AQ devices and i check it with the same cabel https://shop.aquacomputer.de/product_inf…roducts_id=3388 but i make it from another usb cable (70cm lenght). Also i youse SATA power cable. Other devices like pendrives and corsair mini link (for psu monitoring) work fine after pluged to hubby7 . Its NOT hardware ishiu its software or firmware problem
I'm just update bios on may mobo (croshair 6 extrime) and check for usb drivers and hubby7 is stil NOT working with AQ devices!!!
Yes im yousing the latest firmware. Case ports pluged to the hubby7 work exactly the same. Just D5 pump is comunicating with aqusuit. And evry 5 pin cabel i hawe is the same pin layout.
But whay aquaero and vision, fabwork to, is not working thru hubby7 and Aq D5 pump works fine? Now i hawe 5 devices from AQ and not inaf interial usb heders .
Yes, i now. But i dril one new holl and tap it ,one is driled to 10mm and one is oryginał with resctriction and is pluged. When i hawe som time i trai calibrate it.
Thanks for answer On normal loop just with CPU block and 2 radiators (480 ocool xflow) i hawe about 132 max but im modifai flow sensor and remowe insaid resctrictions (use 10mm drilbit .
I want veryfai may flow. Im using https://shop.aquacomputer.de/product_inf…roducts_id=2294 and Aq D5 pump on test loop, 30cm lenght and 10mm Id. Just with flow sensor and pump max i hawe 520 l/h. On minimum pomp rpm (1800) was165 l/h. Its ok?
I hawe the same problem with asus croshair 6 extrime and hubby7. Vision and fabworka and aquaero 6lt do not want worki. Others devices (aq D5 pomp ,pendrivers, corsair link ) work fine. I hawe win10pro and latest driver from AMD. Any sugestions???