Thanks!

Zitat von »WackyWRZ« Is there a way for me to go back to X11 software and firmware, since it was working fine before? Same question. I've update to x.12 from x.11. I didn't remember, but my license was expired on 31/12/19. So I have no activation for the new version and I need to go back to ver.11 to have the aquasuite working again...

Problem solved... I made the mod to my pump. Now it runs from 3500 to 4800rpm and I have readings from 190 to 270lt/h. Maybe the 100lt/h are too near the minimum value that the sensor can read...

Tomorrow I'll try the mod and see what happens

No, without that mod the pump doesn't receive a good pwm signal and runs at a fixed speed. After that mod, I can use the "Power controlled"...

It's not so easy... My D5 pwm isn't compatible with pwm standards and I can't setect the speed. It can run at actual speed or it switches off... I have to make the mod and use the pump like a 3 pin fan (voltage controlled)

I have an Alphacool D5 pwm pump at 2000rpm, 1 EK supremacy evo waterblock, 1 360mm rad. They are connected with 6 45° fittings and 2 straight fittings on the mps400. When the sensor works, it detects 100lt/h. And the pump always run at that fixed speed. So the flow must be always the same...

Hi everybody! I'm a first time user for the Aquacomputer products. I recently bought an Aquacomputer MPSFlow 400 (order nr.93024552 - 21.05.201 I have a problem with this sensor. The sensor is connected to an Aquaero 6 LT with the original Aquabus cable and to the motherboard with the usb cable. It is connected to the liquid system with 2 G1/4" fittings and 14/10 straight tubes. The temperature of the cooling liquid is correctly detected. The flow sensor doesnt' work well. I manually configure t...