I have both Fabwerk 360 and Strimer. For one thing they have different connectors. Strimer has 3-pin chain able connector, much larger than 360 connectors. Does anyone known if connector adapter is available for 360?

Thank you so much for very clear explanation. It all make sense now.

I'm in a process of building a new loop. It's completed but I only been running it "standalone" meaning that computer is off, nothing really get cooled. The loop has two D5 Next Pumps in serial one connected directly to another. It also have Calitemp sensor, which is according to specs should be very accurate. What I observed is that temperatures reported by Pumps (both are very close) are 2 degrees C higher than reported by Calitemp. Which one is correct? Thanks in advance.

This is my first experience with Aquaero and it's ecosystem of devices, please excuse me if this is trivial. I have Aquaero 6XT, two D5 Next pums, High Flow USB sensor, Farbwerk, Quatro, Splitty9. First I install all devices connected both with USB and Aquabus. Run Aquasuite, everything looks good. Checked that all devices have unique Aquabus addresses. Powered off everything. Disconnected all devices from USB (not Aquaero off cause). Started everything and observed the following in Aquasuite. I...