Thanks for the tip InfoSeeker! I assumed that It was per default a fully compliant PWM pump as Singularity Computers use all the time that combination I won’t have any bays so I am rather forced on the LT I will have to re-route some tubes then to make space Cheers

Ah haaaaaa! Thank you very much for the clarification TigerFire13! I thought it was a given that you could have deltas... i was sure it was just a feature of AquaSuite and therefore not related to the HW But then, considering it’s a water cooled build (3* 360) it makes sense to have the virtual sensors as it’s the magic sauce to optimise the system... Therefore i guess the setup would be the same as in the original post but with an aquaero instead of the Quadro (a bit unfortunate as i will have ...

Thank you for your reply InfoSeeker I thought Quadro still had 8 vSensor readings. According to the Quadro page: · Four temperature sensor inputs · Eight further values can be transferred from the PC to the QUADRO using the aquasuite software · Flow sensor input Therefore i assumed it would cover my needs of CPU and GPU temps without the need of an Aquaero 6 as i am cramping up the case quite a bit already

Hi everyone, I am building a new liquid cooled computer computer and I would need some insight from the AquaComputer experts of this forum I will have 12 Corsair LL120 as well as a Protium D5 Pump a high flow sensor and 4 temp points (3 air, 1 for the loop) Looking into all the new goodies of AquaComputer I think that the way to go for this setup would be: 3*(4* LL120 —> 1* Splitty4) —> 1* Fabwerk 360 (for the RGB) —> PC (via USB) —> AquaSuite 3*(4* LL120 —> 1* Splitty4) —> 1* Quadro (for the po...