Suchergebnisse
Suchergebnisse 1-10 von insgesamt 10.
Hi. PC build is about 8 month old. Today was a typical day. I did some work on PC and turned it off. Now I see that pump blinks with alarm sound about low rpm. Temperatures are high, seems that motor isn't working. It can be some software fault or I should RMA it ?
Zitat von »sebastian« The aquasuite works with hwinfo 7 Strange, but after upgrading to hwinfo 7 I do not see it as source. Revert to 6.42 fixed that.
Zitat von »sebastian« Restart the service with the aquasuite. Thanks!
Hello. Upgrade from X37 to X38. Almost all sensors (hwinfo) are gone.
Zitat von »k2viper« I bet there is not enough rubber. It is not a noise or vibration from pc case - it coming from the pump. Yesterday I've taken it from pc and held it in hand - same ultrasonic noise even on low rpm's.
I have D5 Next pump and Watercool Heatkiller Tube reservoir, which has brackets with antivibration rubber. Same awful noise. I can hear at 0% power output (2000 rpm). Pump do not stands on any surface, just attached to reservoir.
Yes, it's a new item. Thanks for the explanation!
Hello. Just received my Ultitube 150 with D5 Next and noticed something. Please take a look on atachments. Scratch (?) is only on the outer side of res.
Hello. I'm planning overall setup scheme and can't manage how to handle RGB control for D5 Next and Ultitube reservoir. For example - can I use my Octo's RGBpx output and single RGBpx cable for simultaneous reservoir ring and pump RGB control? Or ring and pump also should have additional RGBpx cable between them? Also, do I need Aquaero to have pump and it's RGB settings shown in Aquasuite? Or I can just connect my Octo by USB to motherboard and Aquasuite will have all devices? Thanks.