Zitat von »InfoSeeker« https://aquacomputer.de/support.html Thanks for this. It says email takes upto 4 weeks. Hopefully not in my case.

Hi I accidentally stripped the mounting holes for the 3 screws to mount the pump/reservoir. I am unable to find the replacement part for this. I have attached the image of the part, ignore the filter I need the pump top that goes in between the pump and reservoir. Thanks in advance.

Thank you very much

Zitat von »InfoSeeker« Zitat von »CluckyTaco« Hi! Sorry to bump an old thread. Please advise if this is the right type of connector for the this cable. https://www.aliexpress.com/item/4000684976327.html?spm=a2g0o.placeorder.0.0.6bef321esNsKKY&mp=1 Thanks in advance. https://www.molex.com/molex/products/family/picoblade Thank you for the quick response. Are the wires really 28AWG as it says on the cable, because the last black wire is thicker than the other 4? Pictures attached for reference. My...

Zitat von »k2viper« Also this connector may be called JST 1,25mm 5-pin (especially on aliexpress). There are pre-crimpled available, so a custom cable can be made, it should run fine being <3m long. Yes, you can setup curves via aquasuite and then disconnect the cable. But, if doing so, remember that any controller data sources besides D5 NEXT's own water temp sensor would be unavailable that way. Hi! Sorry to bump an old thread. Please advise if this is the right type of connector for the this...

Zitat von »Hufeisen« Zitat von »CluckyTaco« 2. Do you need a permanent USB connection for the aquasuite to configure the Pump? An USB Connection is only required for RGBpx and Firmware Updates. If you dont use RGBpx, you can run the pump without the USB cable. All settings (including Fan curve) are saved on the Pump. Thanks for the clarification. So based on what you are saying I can setup all the fan/pump/temp curves via Aquasuite and after that I can disconnect the cable. I don't plan to use ...

Hi I have a few questions regarding the D5 Next Pump. 1. I plan to use an external radiator with the Pump mounted to it. So I need to run the USB cable from my computer to the pump. Is this the right cable for that and are there longer versions of this cable available? https://shop.aquacomputer.de/product_inf…roducts_id=3487. I think this might be the one https://shop.aquacomputer.de/product_inf…roducts_id=3587. 2. Do you need a permanent USB connection for the aquasuite to configure the Pump? I...