• 18.04.2024, 19:45
  • Registrieren
  • Anmelden
  • Sie sind nicht angemeldet.

 

Suchergebnisse

Suchergebnisse 1-3 von insgesamt 3.

Mittwoch, 28. Juli 2021, 06:05

Forenbeitrag von: »hathornd«

Farbwerk360 problems

Further investigation reveals that yes, there is a short in the Farbwerk360 unit I have. I'll be sending it back. My gaming PC wouldn't work with it, and it did the same thing to my rock-solid HTPC. It has some kind of short on the board that makes the PSU trip off volt-protection and the system won't do anything. It did take a few weeks of waiting for performancepcs to even get em in stock, so I think I'll just be asking for a refund because sending it back to aquacomputer for RMA/warranty eval...

Mittwoch, 28. Juli 2021, 05:33

Forenbeitrag von: »hathornd«

Farbwerk360 problems

Zitat von »Remayz« maybe look at the manual of your motherboard and double check if you didn't plug the USB thin connector backwards. It has happened If you do so, there's chances you connect a 5v line to ground,and trigger your PSU's short circuit protection I checked that out. The USB was wired the right way. I seem to be having a problem with my PSU. I cannot plug in a molex and a sata lead into the PSU, the system won't start. If I plug in only the sata, on any port, it will start perfectly...

Dienstag, 27. Juli 2021, 23:07

Forenbeitrag von: »hathornd«

Farbwerk360 problems

Hi: I picked one of these up finally, and I connected it all together and it kills my system about 1/4 of a second after I power it on. If I unplug the molex from the Farbwerk, the PC will boot after the PSU resets (unplug PSU power from back and replug after about 10 seconds). If I plug it in, it refuses to boot or respond to the power button. I'd hate to think my luck was this rotten. Is this dumb thing dead? It is installed properly, on its own molex lead from the PSU. I followed the directio...