My system is composed of 2 PC connected - one is in the basment. The loop consist of: Pumps: basment: 2xD5 + 1xAquastream Ultra the go trough: 2x360 rads, 1xCPU + 2X GPUs main system: 1xD5 1x420 + 1x280 rads + 1 CPU + 1 GPU block + distroplate The highflow next start to read a flow only when my main D5 goes over 60% I can even disconnect the basement PC and do few more test with a single D5 if that can help - a read of 0 (Zero) just doesn't make too much sense to me

Hi, I just received and installed a highflownext - My system has 3 pumps, two D5 in the Basement and one D5 in a distro plate. On this same system, an older flow-meter (the one I am replacing with the highflownext) was shown reading of about 4.5 L/min. Now wit the highflownext I need to put all the pumps at 100 % to see a reading of 90L/hour - If I set the pumps top 50% (I can still see the water moving (turbulence in my distroplate) .. however, the highflownext is reading 0 (zero) no flow art a...