• 05.04.2026, 08:56
  • Registrieren
  • Anmelden

  • Du bist nicht angemeldet.

 

DDC waterpump not correctly scaling with Output within Aquasuite

Lieber Besucher, herzlich willkommen bei: Aqua Computer Forum. Falls dies dein erster Besuch auf dieser Seite ist, lese dir bitte die Hilfe durch. Dort wird dir die Bedienung dieser Seite näher erläutert. Darüber hinaus solltest du dich registrieren, um alle Funktionen dieser Seite nutzen zu können. Benutze das Registrierungsformular, um dich zu registrieren oder informiere dich ausführlich über den Registrierungsvorgang. Falls du dich bereits zu einem früheren Zeitpunkt registriert hast, kannst du dich hier anmelden.

-SambaL-

Newbie

DDC waterpump not correctly scaling with Output within Aquasuite

Freitag, 27. Februar 2026, 11:57

Hi there.

I have a DDC 4.2 PWM pump connected to a Quadro controller which maxes out @ 4460 RPM when the output power slider is set to 45% and beyond within Aquasuite (version X.85). It is not really a problem because the waterpump is working and adjustable, but I would like it to scale 1:1 like my PWM fans do which are connected to the same controller. It just makes it easier to oversee when setting up curves and such.

I tried adjusting this under the 'Controller Override' settings but I couldn't figure it out. Am I missing something ?


Remayz

Senior Member

Freitag, 27. Februar 2026, 17:10

you need to set the output scale to 0.5.

when setting 100% PWM on your curve, the controller will output 50% to put the pump at full speed.
Edit : i use a DDC so it's tested and working :p

While you're at it you can even create a virtual sensor to divide the pump RPM reading by 2 to get the real impeller speed. looks nicer on the dashboard :thumbsup:

Speedy-VI

Senior Member

Freitag, 27. Februar 2026, 20:53

Zitat von »Remayz«

While you're at it you can even create a virtual sensor to divide the pump RPM reading by 2 to get the real impeller speed. looks nicer on the dashboard :thumbsup:
Is the impellor speed half of the reported pump RPM? Is this specific to the DDC pump or does it also apply to the D5 Next pump?

Ähnliche Themen