Lieber Besucher, herzlich willkommen bei: Aqua Computer Forum.
Falls dies dein erster Besuch auf dieser Seite ist, lese dir bitte die Hilfe durch. Dort wird dir die Bedienung dieser Seite näher erläutert.
Darüber hinaus solltest du dich registrieren, um alle Funktionen dieser Seite nutzen zu können.
Benutze das Registrierungsformular, um dich zu registrieren oder informiere dich ausführlich über den Registrierungsvorgang.
Falls du dich bereits zu einem früheren Zeitpunkt registriert hast, kannst du dich hier anmelden.
Hi,
I am planning to buy an aquaero for my watercooling system.
I would like to know if it is possible to connect a flowmeter from innovatek (rev 2) and a relay PumpControl-O-Matic from innovatek ?
Does I need to buy other accessories for that ?
Thanks a lot for your answer.
Regards
Someone from A-C will probably have to answer the question about the Control-O-Matic as I know nothing about it.
The Aquaero info I have shows that the software will allow you to adjust the calibration for different manufacturer's of flow devices. So I suppose that you probably can hook it up providing that the connectors are the same or you modify them yourself.
The calibration factor intrigued me as I have been concerned about reported flow reduction in the A-C unit. I figure if I check the flow with the standard A-C unit and then bore open the holes through the unit as possible I then can recheck the same flow reading and adjust the calibration factor so it reads the same as before with less flow restriction ;D
04.09.2026, 02:10
Sprache ändern
Registrieren
Anmelden
