• Aqua Computer Forum »
• Weitere Foren »
• English forum »

Lieber Besucher, herzlich willkommen bei: Aqua Computer Forum. Falls dies dein erster Besuch auf dieser Seite ist, lese dir bitte die Hilfe durch. Dort wird dir die Bedienung dieser Seite näher erläutert. Darüber hinaus solltest du dich registrieren, um alle Funktionen dieser Seite nutzen zu können. Benutze das Registrierungsformular, um dich zu registrieren oder informiere dich ausführlich über den Registrierungsvorgang. Falls du dich bereits zu einem früheren Zeitpunkt registriert hast, kannst du dich hier anmelden.

etoel

Junior Member

Tight fit on SB on Asus Maximus Formula

Dienstag, 18. März 2008, 16:30

• 1
• 

I have a twinplex XT di-Design (24152) on the SB on my Asus Maximus Formula and it's a very tight fit as you can see from the picture.



Did I pick the wrong block?
Can I just take off a mm from the edge g the bottom part? I don't like that it's touching the capacitors.

typfred

Junior Member

Re: Tight fit on SB on Asus Maximus Formula

Freitag, 4. April 2008, 02:31

• 2
• 

Hi!

Have u try to cut a small edge of the screw head? I use plastic screws on my board and had cutted the head a little bit. Therefore the screws are going more straight in the holes and the function is the same. I hope I could help.

etoel

Junior Member

Re: Tight fit on SB on Asus Maximus Formula

Freitag, 4. April 2008, 12:02

• 3
• 

Zitat von »typfred«

Hi!

Have u try to cut a small edge of the screw head? I use plastic screws on my board and had cutted the head a little bit. Therefore the screws are going more straight in the holes and the function is the same. I hope I could help.

I'll look into that - thanks. Trying to rotate it slightly too.