I had this with my 2 new PA2's that turned up yesterday, thought I'd share what I had to do to get up and running for anyone else running into this:
- Power off everything
- Connect PowerAdjusts via USB
- Disconnect Aqua bus connectors from PowerAdjust's
- Boot and install the old aquasuite 4.72
- Open aquasuite 4.72 and set the aquabus address for each PA2 (I used 51 & 52)
- Shutdown
- Disconnect the USB and reconnect the Aquabus connectors
- Boot computer again (the PA2's will still shutdown after start boot time but don't worry about it)
- Load AquaSuite 2012
- You will now see two (or however many PA2's you connected) additional fan's
You can now configure a controller for them and set it up the same way as any other fan including setting it to 'Hold minimum power' to stop it powering off after the startboost period.
Mark