• 23.08.2025, 19:44
  • Registrieren
  • Anmelden

  • Du bist nicht angemeldet.

 

Fan stop behaviour on Quadro with new firmware

Hort

Junior Member

Fan stop behaviour on Quadro with new firmware

Dienstag, 21. Februar 2023, 15:29

Hello! Recently I've updated my Quadro to the latest stable software and firmware versions (aquasuite X.59 and 1032 firmware). Previously if I unselect "Hold minimum power" and temperature goes below Minimum temperature - fan stops. When temperature goes above Startup temperature - it starts. After update the fan started to behave weirdly - it can stop without reaching Minimum temperature. Sometimes it keeps starting and stopping all the time if difference between Minimum and Startup temperature is 1-2C (without even reaching Minimum temp and changing temperature at all). Tried to reset device to factory defaults, but this didn't help. I have also aquaero 6 LT with older firmware/aquasuite on a different computer and it stops fans only when temperature is lower than Minimum, not somewhere in the middle

sebastian

Administrator

Dienstag, 21. Februar 2023, 15:57

Make screenshots from your fan and controller settings.

Hort

Junior Member

Dienstag, 21. Februar 2023, 16:21

The fan starts when temperature is 37 (as expected) but stops at around 36.29, although minimum temp is 35
»Hort« hat folgendes Bild angehängt:
  • Fan1.png

sebastian

Administrator

Dienstag, 21. Februar 2023, 16:27

Yout first 3 point are very close to 0%.
Set only the first point too 0, all other > 0

Hort

Junior Member

Dienstag, 21. Februar 2023, 17:06

Zitat von »sebastian«

Yout first 3 point are very close to 0%.
Set only the first point too 0, all other > 0

I have "minimum power in" set as 30% and fan spins at 30% before stopping, so it should be 30 in that case, not 0?

Hort

Junior Member

Dienstag, 21. Februar 2023, 17:18

I've tried your suggestion - and it works now. Last 3 point were indeed 0%. Thanks a lot!

Hort

Junior Member

Dienstag, 21. Februar 2023, 17:50

It should be some kind of bug with rounding - first 3 points were 0%, but 4th - 2.1% already. I would expect 1.x% at least in between, not all 0-s. To get this I used Automatic setup.

Hort

Junior Member

Dienstag, 21. Februar 2023, 17:57

It looks like it's a bug with Manual setup - when I used Automatic setup, I see that at least some of them are not 0-s, but when I try to select them one by one in Manual setup - they are all changed to 0% automatically, except 4th 2.1%

Ähnliche Themen