Greetings! I purchased Aquacomputer parts to do 2 independent loops. The Aquacomputer equipment I have is listed below:
- 1 Aquaero 6 PRO.
- 1 Aquabus x4.
- 1 Real Time Clock module.
- 1 Farbwerk
- 2 Aqualis reservoir and pump adapter (with fill sensor),
- 2 Illumination rings for the reservoir.
- 2 High flow sensors (mechanical).
- 4 Calitemp temp sensors
- 1 Splitty9 (set to Aquabus mode)
I am connecting all this to The Tower 900 which supports 2X 560 radiators using 4X 140mm fans each plus some other fans which total 12 fans to control.
I wanted to control them all with PWM but the Aquaero only has 4 fan outputs. One of the fan outputs will have to be used with one of the flow sensors as there is only one dedicated flow sensor on the Aquaero 6 PRO.
I was considering purchasing 2 Poweradjust modules but I read that you can use an Aquaero 6 LT as a slave unit.
QUESTION 1: If I get a 6 LT, will I be able to use the 2 combined dedicated flow sensor inputs, all 8 PWM fan controls and all the Aquabus connections from both units? I'd still be lacking control to 4 fans.
QUESTION 2: Also, the illumination rings come with a cable that needs to be connected to the BUS connector on the D5 NEXT pump, which is also the Aquabus connector for the pump. Can I connect the reservoir illumination rings directly into the Aquaero
in some other way, or maybe to the Faberwerk using an adapter or by modifying the connector?
QUESTION 3: How exactly do I connect the 6 LT as a slave? What cable is required to link both of them, I read something about flashing the unit etc.
I thank you all in advance, this is my first custom watercooling project and it is massively complicated, any help would be greatly appreciated!