• 25.08.2025, 18:04
  • Registrieren
  • Anmelden

  • Sie sind nicht angemeldet.

 

Aquaero g xt not seeing MPS 200 through aquabus

Dried_Yams

Newbie

Aquaero g xt not seeing MPS 200 through aquabus

Dienstag, 6. März 2018, 08:50

I connected my mps 200 through usb I updated the firmware, then connected it via aquabus and disconnected the usb and it doesnt see it even under the aquabus tab it doesnt see anything ive connected the aquabus to both ports with no success what do I do?

InfoSeeker

Senior Member

Dienstag, 6. März 2018, 16:21

If you haven't yet since the firmware update, power down the system, turn off the PSU and unplug the mains cable.
Wait at least 1 minute for all components to drain, then plug back in, turn on PSU & start the system.

Dried_Yams

Newbie

Dienstag, 6. März 2018, 20:03

Ivd tried that as well still nothing

InfoSeeker

Senior Member

Dienstag, 6. März 2018, 21:45

is the MPS 200 set to aquabus priority?

Shoggy

Sven - Admin

Mittwoch, 7. März 2018, 15:40

Zitat von »InfoSeeker«

is the MPS 200 set to aquabus priority?

Not necessary (and also not possible) anymore with current firmware.

Since the USB cable has been disconnected afterwards: are you using a 4-pin aquabus cable because only this one will work? If it is a 3-pin cable the sensor would get no power, so USB must stay connected in this case.

Ähnliche Themen