• 22.07.2025, 01:32
  • Register
  • Login

  • You are not logged in.

 

Bug: After Update, Flow Sensor connected on Fan 1 of Aquaero 6 no longer works

GAqua

Junior Member

Bug: After Update, Flow Sensor connected on Fan 1 of Aquaero 6 no longer works

Sunday, November 12th 2017, 2:31am

I have an Aquaero 6. I just updated to Aquasuite 2017-3.1.

I backed up my settings and updated the Aquaero firmware after the software update. I loaded the previous settings back.

Now the flow sensor that was attached to fan1 is no longer working. It thinks its a fan again.

wpuser

Senior Member

Sunday, November 12th 2017, 3:27am

The flow sensor have to be connected to the "aquabus low" port now.

This post has been edited 1 times, last edit by "wpuser" (Dec 2nd 2017, 7:57pm)

GAqua

Junior Member

Sunday, November 12th 2017, 6:31am

Thanks, i'll check that out.

GAqua

Junior Member

Friday, December 1st 2017, 8:10pm

Quoted from "wpuser"

The flow sensor have to be connected to to "aquabus low" port now.



This indeed works.

While the notes say that you can still use the Fan-1 port for a flow sensor, this is NOT true. If you only have 2 flow sensors, they have to go to the FLOW port and the AQUABUS LOW ports first.

GTXJackBauer

Full Member

Saturday, December 2nd 2017, 3:03am

Quoted from "GAqua"

Quoted from "wpuser"

The flow sensor have to be connected to to "aquabus low" port now.



This indeed works.

While the notes say that you can still use the Fan-1 port for a flow sensor, this is NOT true. If you only have 2 flow sensors, they have to go to the FLOW port and the AQUABUS LOW ports first.


That's correct.

Similar threads