• 16.06.2025, 05:47
  • Register
  • Login

  • You are not logged in.

 

PowerAdjust 3 Ultra and Start Boost.

Syberon

Junior Member

PowerAdjust 3 Ultra and Start Boost.

Friday, March 8th 2019, 4:08am

Every time when connected to PowerAdjust 3 fans spins up it starts at full voltage fot 10 seconds. My PowerAdjust 3 connected to Aquaero 6LT by aquabus and connected by USB with same time. I have disabled the start boost in PowerAdjust Fan tab and in Aquaero Fans tab but it doesn't helps - fan spins up at full speed for 10 seconds even is start boost disabled. I don't want to hear this loud sound at every PC start. All my another fans, connected to Aquaero 6 starts normally with 600rpm.



How to setup PowerAdjust not to use StartBoost and spins up at 33% like my other fans?

Dundys

Full Member

Friday, March 8th 2019, 4:29am

It's possible that the "start boost" is enabled in PA3 advanced menu ( fan tab) that can be accessed via-USB cable only. Connect that PA3 directly via-USB cable only, then under PA3 menu uncheck the "start boost" and save it, then you can reconnect that PA3 via-aquabus again

This post has been edited 10 times, last edit by "Dundys" (Mar 8th 2019, 5:10am)

Syberon

Junior Member

Friday, March 8th 2019, 5:14am

Quoted from "Dundys"

It's possible that the "start boost" is enabled in PA3 advanced menu ( fan tab) that can be accessed via-USB cable only.

The fan tab of PA3 connected by USB you can see on first attached screenshot. StartBoost is disabled on this tab.

Dundys

Full Member

Friday, March 8th 2019, 5:49am

Sorry I didn't see it :rolleyes:.... its probably me, but that menu looks add, like something is missing I presume you have updated PA3's firmware. I have 7x PA3 Ultra, in which 4 of them controlling 4 of my D5 pumps. I remember whey back I had exactly the same issue when don't mater how I set the "start boost" in PA3 via-aquabus, it would start my pumps and some of the fans at MAX speed for 10 seconds. It took me a while to figure that out that until I connected every PA3 separately via-USB cable first, then disabling "start boost" there allowed me to adjust the "start boost" via-aquabus to my liking.

This post has been edited 6 times, last edit by "Dundys" (Mar 8th 2019, 6:12am)

Syberon

Junior Member

Friday, March 8th 2019, 4:34pm

Thanks! This realy helped. I disconnected the aquabus cable and there are checked startboost option appeared in PA3 Fan tab. Disabling this option and connectiong aquabus again totally resolved this problem.

Similar threads