• 27.08.2026, 09:25
  • Register
  • Login

  • You are not logged in.

 

Quadro Curve Shape

Dear visitor, welcome to Aqua Computer Forum. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Ytterbium

Full Member

Quadro Curve Shape

Wednesday, December 14th 2022, 8:52pm

I'm setting up my fans.

If the curve shape for a fan custom to each fan or a global setting?

When I switch between the different ones it seems to reset to the other curve, just not sure how it supposed to be?

MotoMazz

Junior Member

Wednesday, December 14th 2022, 10:23pm

If the QUADRO is the same as the OCTO or even the Aquaero, you will have 1 curve controller per fan output, so you SHOULD be able to control each fan output individually using a curve controller.
With the OCTO, it's pretty clever, because you can set up one curve controller and then copy those settings to the other 7 fan curve controllers. I'm pretty sure the same goes for the QUADRO.

This post has been edited 1 times, last edit by "MotoMazz" (Dec 14th 2022, 10:25pm)

/MotoMazz

Remayz

Senior Member

Wednesday, December 14th 2022, 10:38pm

when you've made your fan curves, go to the profiles tab and SAVE the damn settings to one of the Quadro profiles :p
Otherwise, when you change profiles, all your hard work is lost

InfoSeeker

Senior Member

Wednesday, December 14th 2022, 10:42pm

As MotoMazz stated, each port has it's own controller. If you want a global setting, make a controller for a fan, then copy to the other fans. (SHORT CLIP)

Ytterbium

Full Member

Wednesday, December 14th 2022, 11:56pm

I think it a bug in aquasuite then since it just doesn't display it correctly.

InfoSeeker

Senior Member

Thursday, December 15th 2022, 2:46am

Any screenshots you can share?

Ytterbium

Full Member

Thursday, December 15th 2022, 11:14am

I started with both fans with 0 curve, I then edit this fan to give the 20 curve.



When I switch to the other fan you can see its like the curve from the other fan is in settings, although I assume based on comments that isn't true, and the picture shows that its still linear

sebastian

Administrator

Thursday, December 15th 2022, 11:32am

The slider is ONLY for a initial curve shape setup.


When you switch between the fans you have one indivual curve for eache fan.
Everything looks right so far.

Ytterbium

Full Member

Thursday, December 15th 2022, 1:35pm

OK, I find it a little confusing from a useability perspective but I get your point.

sebastian

Administrator

Thursday, December 15th 2022, 1:40pm

Quoted from "Ytterbium"

OK, I find it a little confusing from a useability perspective

If you drag and drop points manually or change values, what should the slider adjust to?
This is only possible during the initial creation of a curve.

Similar threads