Dear visitor, welcome to Aqua Computer Forum. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.
I have the AC Flow Meter and I will be using 1/2" barbs with G1/4 BSPP threading. I just took a look inside the opening of the flow meter to see that it narrows DRASTICALLY.
Wouldn't this have a terrible impact on my flow rate when included in my loop?
-d3d
Probably if you are using a high flow 1/2" system as the flowmeter was designed to be used on a system that does not need "high flow" in order to work.
well not necessarily... if you have the time.. i would check the temps of when you have the sensor.. and when you don't have the sensor... if they are a big difference then scrap the sensor.. but in my honest opinion.. I don't think the flow makes that much of a difference (especially if you have aqua computer blocks).
Ed
Alright, I'll keep that in mind. Thanks.
What blocks are you planning to use?
I'm using a DangerDen Maze4 gpu block and a Swiftech Apogee cpu block.
I'd look for another flowmeter then - the AC one isn't suited to your loop.
Great, I appreciate it.
I just figured the AC flowmeter would be my only choice because I need the specialized output designed for an Aquaero.
You find any alternatives? Should I try to enlarge the flow meter hole?
I'm familiar with drill/tapping, I did it for the aquatube for 1/2" fittings..
20.06.2025, 05:30
Change Language
Register
Login
