• 20.08.2025, 07:48
  • Register
  • Login
  • You are not logged in.

 

virtualrain

Junior Member

Aquaero firmware not remembering relay settings!

Thursday, October 18th 2007, 12:06am

Hi, both my Aquaero's will not retain the relay settings after a power cycle.

I have tried to set them both to "Power Switch" but everytime the power is cycled on the PC, they come up set to "ATX-Break Line" which renders my PC's power switch unusable. I have been forced to disconnect my power switch from the motherboard and use the powerswitch on the motherboard instead... otherwise I can't even power my computer on.

Thanks for any help with sorting this out.

gr3if

God

Re: Aquaero firmware not remembering relay setting

Thursday, October 18th 2007, 1:53am

You know that you have to save the settings in the eeprom?

virtualrain

Junior Member

Re: Aquaero firmware not remembering relay setting

Thursday, October 18th 2007, 5:15am

Yes... good suggestion, but I'm using the "Save data to EEPROM" in the "Extras" menu after adjustments. It seems to remember everything else I set, except for the relay parameters.

gr3if

God

Re: Aquaero firmware not remembering relay setting

Thursday, October 18th 2007, 8:11pm

Hm weird.

Latest Firmware? Latest Aquasuite?

virtualrain

Junior Member

Re: Aquaero firmware not remembering relay setting

Thursday, October 18th 2007, 10:31pm

Yes to both. It also happens on both of my Aquaero's so it's not an isolated problem.

gr3if

God

Re: Aquaero firmware not remembering relay setting

Thursday, October 18th 2007, 10:34pm

Can you check if this is not a cable related issue? Maybe with another cable? And check the pins twice plz.

x-stars

God

Re: Aquaero firmware not remembering relay setting

Friday, October 19th 2007, 1:38am

Long time (about 2 years) ago, but in that times you had to flash the firmware after changing the relais-setting because the aquaero needs to know the settings before booting and thus before there is eeprom-access. So, set it once again to your favourite setting and then reflash the firmware. Don't forget the eeprom-reset afterwards.

"Live free or die: Death is not the worst of evils."

virtualrain

Junior Member

Re: Aquaero firmware not remembering relay setting

Monday, October 29th 2007, 7:17pm

Quoted from "x-stars"

Long time (about 2 years) ago, but in that times you had to flash the firmware after changing the relais-setting because the aquaero needs to know the settings before booting and thus before there is eeprom-access. So, set it once again to your favourite setting and then reflash the firmware. Don't forget the eeprom-reset afterwards.



This worked. Thanks!