• 22.08.2025, 01:22
  • Register
  • Login

  • You are not logged in.

 

Farbwerk via 4 pin aquabus.

BillLucas

Newbie

Farbwerk via 4 pin aquabus.

Saturday, July 23rd 2016, 6:45pm

Hello all, first post so be gentle.

I have my farbwerk (non Bluetooth) hooked up to my 6XT using the aquabus connectors on my real time clock module. However without a USB plug I have no control over the unit, only the ability to send it sensor information that works.

I was wondering if this is a intended feature or I'm not quite good enough on aquasuite to figure it out. I made a led controller in the 6XT controller page and assigned outputs correctly, but the controller simply doesn't respond.

Thanks for any help you can provide :)

P.S device ID 20 as suggested by AC themselves. Not conflict there

This post has been edited 1 times, last edit by "BillLucas" (Jul 23rd 2016, 6:47pm)

Fieldrider

Senior Member

Saturday, July 23rd 2016, 8:21pm

You need to connect the Farbwerk via USB first and then set the Input-Signal to "Aquabus". Then you should be able to let the Aquaero control the Farbwerk :)

Shoggy

Sven - Admin

Saturday, July 23rd 2016, 9:00pm

To be a bit more precise: in the controller tab you have to change the mode for every channel to be controlled by an external source.

BillLucas

Newbie

Sunday, July 24th 2016, 1:32am

Thanks for the assistance, in my haste to get the wiring done I unplugged the USB that I had been using, without thinking of setting changes which would have to occur first. I'll report back tomorrow and close the thread when resolved :)

Similar threads