• 31.08.2025, 22:52
  • Register
  • Login

  • You are not logged in.

 

Splitty4 aRGB strips acting in parallel rather than series

Dear visitor, welcome to Aqua Computer Forum. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

f1fan07

Newbie

Splitty4 aRGB strips acting in parallel rather than series

Thursday, January 28th 2021, 3:17am

I feel like I am going nuts..
Issue, aRGB strips acting in parallel rather than series, both hooked up with adapters to corsair headers. Tested on both versions of the Splitty4.

No matter how I define RGB controllers in Aquasuite, the settings just mimic across both. I just feel like I'm missing a config or something. Any help would be appreciated.

I have a similar setup in a system with 3x corsair ML120 rgb fans and an argb strip built into the Lian Li PC-O11XL with corsair 4 pin adapter and everything behaves as expected. I have the 3 fans set up as one block of 12 leds and the strip as another block of 28 leds. I can control them as I see fit.

Setup:

D5 NEXT with aquabus connector and rgbpx connector into splitty4
Aquacomputer 53270 RGBpx 30 aRGB strip plugged into aquacomputer RGBpx cable to aquacomputer adapter 53285 to corsair 4-pin adapter
Heatkiller size M addressable RGB strip with adapter to corsair 4-pin
Specifications:
Voltage: 5V
Connector: 3-Pin (5VDG, 5V)
LED: 21x SMD RGB

This post has been edited 5 times, last edit by "f1fan07" (Jan 30th 2021, 11:22pm)

Hufeisen

Senior Member

Friday, January 29th 2021, 3:54pm

Can you upload a picture of the connections?
Your setup is hard to understand with so many adapters.
And post a link to the corsair 4-pin adapter you are using.

This post has been edited 1 times, last edit by "Hufeisen" (Jan 29th 2021, 4:04pm)

cptninc

Full Member

Friday, January 29th 2021, 6:42pm

Try running the strips connected to each other in series using the built in connectors. I believe those are intended to be used with their built in passthrough rather than the arrangement in the Splitty4.

Similar threads