• 17.06.2025, 02:47
  • Register
  • Login

  • You are not logged in.

 

Quadro Curve Shape

Ytterbium

Full Member

Quadro Curve Shape

Wednesday, December 14th 2022, 8:52pm

I'm setting up my fans.

If the curve shape for a fan custom to each fan or a global setting?

When I switch between the different ones it seems to reset to the other curve, just not sure how it supposed to be?

MotoMazz

Junior Member

Wednesday, December 14th 2022, 10:23pm

If the QUADRO is the same as the OCTO or even the Aquaero, you will have 1 curve controller per fan output, so you SHOULD be able to control each fan output individually using a curve controller.
With the OCTO, it's pretty clever, because you can set up one curve controller and then copy those settings to the other 7 fan curve controllers. I'm pretty sure the same goes for the QUADRO.

This post has been edited 1 times, last edit by "MotoMazz" (Dec 14th 2022, 10:25pm)

/MotoMazz

Remayz

Senior Member

Wednesday, December 14th 2022, 10:38pm

when you've made your fan curves, go to the profiles tab and SAVE the damn settings to one of the Quadro profiles :p
Otherwise, when you change profiles, all your hard work is lost

InfoSeeker

Senior Member

Wednesday, December 14th 2022, 10:42pm

As MotoMazz stated, each port has it's own controller. If you want a global setting, make a controller for a fan, then copy to the other fans. (SHORT CLIP)

Ytterbium

Full Member

Wednesday, December 14th 2022, 11:56pm

I think it a bug in aquasuite then since it just doesn't display it correctly.

InfoSeeker

Senior Member

Thursday, December 15th 2022, 2:46am

Any screenshots you can share?

Ytterbium

Full Member

Thursday, December 15th 2022, 11:14am

I started with both fans with 0 curve, I then edit this fan to give the 20 curve.



When I switch to the other fan you can see its like the curve from the other fan is in settings, although I assume based on comments that isn't true, and the picture shows that its still linear

sebastian

Administrator

Thursday, December 15th 2022, 11:32am

The slider is ONLY for a initial curve shape setup.


When you switch between the fans you have one indivual curve for eache fan.
Everything looks right so far.

Ytterbium

Full Member

Thursday, December 15th 2022, 1:35pm

OK, I find it a little confusing from a useability perspective but I get your point.

sebastian

Administrator

Thursday, December 15th 2022, 1:40pm

Quoted from "Ytterbium"

OK, I find it a little confusing from a useability perspective

If you drag and drop points manually or change values, what should the slider adjust to?
This is only possible during the initial creation of a curve.

Similar threads