sind doch welche dabei

oder willst du größere haben?

Mit ein wenig geschick könnte man sowas auch selber bauen .

Normalerweise reicht doch ne Stichsäge, Feile und nen Akkuschrauber (mir zumindestens ).
Aber ohne so etwas geht das wirklich nicht

My reply is in English to make it easier for my to reply.

I own a 360 and also thought the risk of a tumbling too high (because we have a kid and a cat). I used two narrow u-profiles of aluminium (about 5 or 10 mm wide) with a lenght about 40 to 50 cm. I have removed the original 4 stands and made two holes in each u-profile to match the 2 x two holes of the screws. The profile has to be narrow because it has to fit inbetween the other screws at the bottom. When you let the opening of the u-profile face the floor your screws will hide inside the profile. You can use the original screws. It's up to you to make the holes on the end of the profile or in the middle. For me I choose to make them at the end so I could make them fixed underneath the pipes of my central heating. As a result you can't tell from the front that there are u-profiles underneath the 360, invisible untill you look behind in. I also put some glider vilt under the strips to let it glide over my floor (laminated) to prevent it from damaging the floor.

Quoted from "Speedy Donderball"

My reply is in English to make it easier for my to reply.

I own a 360 and also thought the risk of a tumbling too high (because we have a kid and a cat). I used two narrow u-profiles of aluminium (about 5 or 10 mm wide) with a lenght about 40 to 50 cm. I have removed the original 4 stands and made two holes in each u-profile to match the 2 x two holes of the screws. The profile has to be narrow because it has to fit inbetween the other screws at the bottom. When you let the opening of the u-profile face the floor your screws will hide inside the profile. You can use the original screws. It's up to you to make the holes on the end of the profile or in the middle. For me I choose to make them at the end so I could make them fixed underneath the pipes of my central heating. As a result you can't tell from the front that there are u-profiles underneath the 360, invisible untill you look behind in. I also put some glider vilt under the strips to let it glide over my floor (laminated) to prevent it from damaging the floor.

I can only say to this:
NICE

ich habe mein XT 720 Mark III

auf eine rollbare Carrara Marmorbank montiert.

so ist es mobil.

Lochbohrungen sind doch einfach zu machen..reicht ein guter Akkuschrauber..ein wenig wasser

ein paar Unterlegscheiben Inbusschrauben ein wenig Geschick & fertig


Hier ein Foto, fertig montiert, aber das Ganz noch nicht eingebau,t da noch in der Dichtungstestphase


greets

satorius

Quoted from "Chriss85"

Größere wenns welche gibt ???? oder son stand teil wo ich das aquaduct dann so drauf stelle oder rein stelle weiß nicht ob es so was gibt das es halt stabiler steht .danke lg chriss

Das Aquaduct sieht bestimmt auf schwarzem Mamor hammer gut aus. Schau doch mal beim Bestatter, ob Du einen Rest bekommen kannst, den er ein bisschen bearbeitet (Abkanten, glätten).

Gruß
Olaf