• 14.04.2026, 00:17
  • S’inscrire
  • Connexion

  • Vous n’êtes pas connecté.

 

Aquaro 5 Reboot problem 1012 firmware

Bonjour, visiteur, bienvenue sur les forums Aqua Computer Forum. Si c’est votre première visite, nous vous invitons à consulter l’Aide. Elle vous expliquera le fonctionnement de cette page. Pour avoir accès à toutes les fonctionnalités, vous devez vous inscrire. Pour cela, veuillez utiliser le formulaire d’enregistrement, ou bien lisez plus d’informations sur la procédure d’enregistrement. Si vous êtes déjà enregistré, veuillez vous connecter.

sparkeyrr

Junior Member

Aquaro 5 Reboot problem 1012 firmware

mardi 21 juin 2011, 11:42

I have a aquaro 5 connected to 3 power adjust ultras on hi speed aqua bus and 1 multi switch and tube meter connected on low speed aqua bus via y cable all flashed to latest firmware.Intermittently the aquaro 5 reboots .This is very annoying not to mention concerning.I wish to install these aquaro 5 devices into several Hi end server’s but lack the confidence in their robustness at this stage.Is this just a software bug or does my device have issues? ?(

Phatboy69

Full Member

mardi 21 juin 2011, 12:10

I doubt its a bug, its more likely a config issue. If the unit encounters conflicts it will reboot. I havent had a reboot yet accept when I had conflicting aquabus IDs on the PA2s or once when I had corrupt data in the A5 after a firmware update.
It seems some of the data structures may change between upgrades and its best to reset everything to defaults after a firmware upgrade. Its a pain but it sorts out the kind of problem your experiencing. Before you reset everything though, just check you dont have any conflicts on the Aquabus.
I am Intel of Borg. Resistance is futile. You will be assimilated.

i7 3930K @5Ghz - X79 ASUS Rampage IV Extreme - 4x SLI GTX580 - 16GB DDR3-2000 - 4x GTX 360 rads 24x CM fans - Aquaero 5 XT +6 PA2 Ultras - 2 x Enermax 1500W PSU - MM Extended Ascension Case - 2 x 452x2 Res and 4 x D5 - 3 x 24" Acer H243H LCD

sparkeyrr

Junior Member

rebooting issue

mercredi 22 juin 2011, 05:08

Ant suggestions on how to fault find this sort of issue?I have addressed ultras 50,51,52,Must admit since Multi switch has been added frequency of reboots seems to have increased a bit.So hard to know whether you have faulty parts or firmware. ?(

Shoggy

Sven - Admin

lundi 27 juin 2011, 10:27

The aquabus uses a pretty simple communication protocol without a special error connection. I just guess your problem is based on some communication problems.

sparkeyrr

Junior Member

rebooting problem

mercredi 29 juin 2011, 07:00

Problem was caused by cold cathode lighting .When I disconnected rebooting issue stopped

Discussions similaires