• 11.10.2025, 04:31
  • S’inscrire
  • Connexion
  • Vous n’êtes pas connecté.

 

Bonjour, visiteur, bienvenue sur les forums Aqua Computer Forum. Si c’est votre première visite, nous vous invitons à consulter l’Aide. Elle vous expliquera le fonctionnement de cette page. Pour avoir accès à toutes les fonctionnalités, vous devez vous inscrire. Pour cela, veuillez utiliser le formulaire d’enregistrement, ou bien lisez plus d’informations sur la procédure d’enregistrement. Si vous êtes déjà enregistré, veuillez vous connecter.

Mega Man

Junior Member

i need help with aquaero 6xt + multiswitch setup

samedi 3 mai 2014, 18:01

ok. so i can use the multiswitch via usb and aquasuite 4.xx without issue.

updated to most recent firmware.

reinstalled aquasuite 2014.

shut off, installed jumper 3 and removed usb.

installed aquabus cable on multiswitch ( both aquabus channels ) and on LOW speed aquabus on aq6xt.

i can not get aquaero 2014 to recognize it, am i doing something wrong ?

micpt

Junior Member

lundi 5 mai 2014, 20:42

when connected via aquabus - you will find the multiswitch options under Aquero Output. There you will find the 8 LED Out´s and also the 8 Power Out´s.
Via Aquabus MS will not be shown as own unit.

In my Screenshot Multiswitch options start with MS1

Ce message a été modifié 1 fois. Dernière modification effectuée par "micpt" (5 mai 2014, 20:45)

Mega Man

Junior Member

mardi 6 mai 2014, 04:03

that is the problem.

it is not showing up, it does not even show anything connected via the aquabus ( under settings- devices connected via aquabus )

sebastian

Administrator

mardi 6 mai 2014, 09:35

From the multiswitch manual:

Citation

Jumper position 5: USB/aquabus
This jumper configures which interface of the multiswitch is active.
Jumper open: USB enabled, aquabus disabled
Jumper closed: aquabus enabled, USB disabled

Mega Man

Junior Member

mardi 6 mai 2014, 14:55

i knew i forgot something stupid, thanks !~ will test now