• 20.07.2025, 01:45
  • S’inscrire
  • Connexion

  • Vous n’êtes pas connecté.

 

Ask how to set up the Virtual Flows Sensor for D5 Next Pump.

Hyeonwoo_H

Newbie

Ask how to set up the Virtual Flows Sensor for D5 Next Pump.

mardi 25 décembre 2018, 15:32




Hello~

I received 'D5 Next' pump on Christmas Eve to Ttorysystems in Korea.


By the way, Virtual Flow Sensor does not work, do I need additional configuration?


I tried the calibration several times by shutting off the ball valve as described, but it still does not change at 0L / h.


I've tested the pump speeds varying, but the results are the same. :wacko:


I tried blocking with a ball valve on an aqua filter. Should I block the outlet directly?


Please~ Help..... ;(



My system is structured like this. "HeatKiller D5 Combo Reservoir + D5 Next Pump" -> "360 Radiator" -> "CPU Block" -> "360 Radiator" -> "GPU Block" -> "Aqua Computer Filter" -> "Reservior"

Firmware 1003.

Ce message a été modifié 2 fois. Dernière modification effectuée par "Hyeonwoo_H" (25 décembre 2018, 18:24)

wpuser

Senior Member

mercredi 26 décembre 2018, 13:59

You need at least a flow of 80 liters per hour and you need the right coolant (one of these: Click)

Hyeonwoo_H

Newbie

mercredi 26 décembre 2018, 14:54

I changed the pump from the loop that was already built and removed the flowmeter and the thermometer that were already installed.

I used the D5 40% PWM setting in the existing configuration.
At this time, the flow rate is 2.76L / m, which is calculated 165L / h, so i think about the flow rate seems to be no problem..





Should I preserve the pressure in the loop when I shut off the loop?

I open the lid of the water bottle once to remove the air bubble.

Discussions similaires