Bonjour, visiteur, bienvenue sur les forums Aqua Computer Forum. Si c’est votre première visite, nous vous invitons à consulter l’Aide. Elle vous expliquera le fonctionnement de cette page. Pour avoir accès à toutes les fonctionnalités, vous devez vous inscrire. Pour cela, veuillez utiliser le formulaire d’enregistrement, ou bien lisez plus d’informations sur la procédure d’enregistrement. Si vous êtes déjà enregistré, veuillez vous connecter.
Hi,
I am planning to buy an aquaero for my watercooling system.
I would like to know if it is possible to connect a flowmeter from innovatek (rev 2) and a relay PumpControl-O-Matic from innovatek ?
Does I need to buy other accessories for that ?
Thanks a lot for your answer.
Regards
Someone from A-C will probably have to answer the question about the Control-O-Matic as I know nothing about it.
The Aquaero info I have shows that the software will allow you to adjust the calibration for different manufacturer's of flow devices. So I suppose that you probably can hook it up providing that the connectors are the same or you modify them yourself.
The calibration factor intrigued me as I have been concerned about reported flow reduction in the A-C unit. I figure if I check the flow with the standard A-C unit and then bore open the holes through the unit as possible I then can recheck the same flow reading and adjust the calibration factor so it reads the same as before with less flow restriction ;D
10.07.2026, 22:44
Changer la langue
S’inscrire
Connexion
