Bonjour, visiteur, bienvenue sur les forums Aqua Computer Forum. Si c’est votre première visite, nous vous invitons à consulter l’Aide. Elle vous expliquera le fonctionnement de cette page. Pour avoir accès à toutes les fonctionnalités, vous devez vous inscrire. Pour cela, veuillez utiliser le formulaire d’enregistrement, ou bien lisez plus d’informations sur la procédure d’enregistrement. Si vous êtes déjà enregistré, veuillez vous connecter.
I have two tubemeter USB and I connect it like this :

*There Internal USB Expansion between the tubemeter and the motherboard.. http://www.amazon.com/gp/product/B0031ESKJA
Often all the tubemeters do not work, and sometimes only one tubemeter working with aquasuite !
Is it one previously faced the same problem??
Thanks,
I tried to connect it directly to the board, but the same problem!
I think the problem is that the tubemeters might not have a changeable address like the PA2 and mps.
One other user has two tubemeters installed and if I remember correctly he connected one via USB and the other is connected to the low speed Aquabus connector. This requires a four wire connector and there is not quite enough room to use a five pin USB connector. So use a four wire Aquabus cable and you should be fine.
Thank U very much Larry
Was your probles resolved? I too am running the same tube meter and running into all kinds of difficulties. sometimes the LED blinks on it, sometimes it does not, always reports 90% lvl have never seen it budge by even a single percentage. I am wondering if my unit is buggered and not relaiable. Looking for more advice specifidcally on when the led on the tube meter should be flashing and for how long.