• 21.08.2025, 17:49
  • S’inscrire
  • Connexion

  • Vous n’êtes pas connecté.

 

D5 pump tach lead

stevebit56

Junior Member

D5 pump tach lead

mardi 24 juin 2014, 21:43

I have a simple question I have a alphacool D5 pump that has a single wire in a 3 pin fan header connector where do I hook this up to on the aquaero 6 so I can see the rpm in the software and can I set the input to shut down the computer if the rpm signal goes to zero?
:P [color

Namron

Full Member

mercredi 25 juin 2014, 08:53

Using one of these Cables should do the trick :) ... Some use the motherboard CPU fan header (using the AQ 5) & then set the bios for a shut on low rpm's, But now the AQ 6 has much better power outage this I guess would be the easiest route to use now...


N.

Jakusonfire

Full Member

samedi 28 juin 2014, 09:16

One way is to just plug that single RPM wire into any available fan header on the Aquaero. That will give you the RPM's and you can set a fan RPM alarm for that header that will first warn if no RPMs are detected for several seconds and then shut down the computer by simulating a button press of a keyboard power button. The PC needs to be set to shut down on that button press rather than hibernate or sleep though.

Ce message a été modifié 1 fois. Dernière modification effectuée par "Jakusonfire" (28 juin 2014, 09:17)

Discussions similaires