• 16.09.2025, 14:59
  • S’inscrire
  • Connexion

  • Vous n’êtes pas connecté.

 

MPS 500 as a pump outlet & return inlet pressure sensor

Bonjour, visiteur, bienvenue sur les forums Aqua Computer Forum. Si c’est votre première visite, nous vous invitons à consulter l’Aide. Elle vous expliquera le fonctionnement de cette page. Pour avoir accès à toutes les fonctionnalités, vous devez vous inscrire. Pour cela, veuillez utiliser le formulaire d’enregistrement, ou bien lisez plus d’informations sur la procédure d’enregistrement. Si vous êtes déjà enregistré, veuillez vous connecter.

Enser

Junior Member

MPS 500 as a pump outlet & return inlet pressure sensor

mardi 16 février 2016, 18:17

As the title says (MPS 500 as a pump outlet & return inlet pressure sensore), I would like to sanity check how this particular setup works (NOT using it as a fill sensor).

I have EK D5 tops, which have 2x outlet & 2x inlet ports. I was going to have normal out/in tubing going to 1 in & 1 out, and use the other in/out to run through the MPS 500. I have read the documentation, but its rather sparse on this setup. Opinions on this setup?
Thanks in advance!

GTXJackBauer

Full Member

RE: MPS 500 as a pump outlet & return inlet pressure sensor

mercredi 17 février 2016, 01:02

Citation de "Enser"

As the title says (MPS 500 as a pump outlet & return inlet pressure sensore), I would like to sanity check how this particular setup works (NOT using it as a fill sensor).

I have EK D5 tops, which have 2x outlet & 2x inlet ports. I was going to have normal out/in tubing going to 1 in & 1 out, and use the other in/out to run through the MPS 500. I have read the documentation, but its rather sparse on this setup. Opinions on this setup?
Thanks in advance!
I know this doesn't answer your question but what D5 pumps are you using?

Discussions similaires