I have a twinplex XT di-Design (24152) on the SB on my Asus Maximus Formula and it's a very tight fit as you can see from the picture.



Did I pick the wrong block?
Can I just take off a mm from the edge g the bottom part? I don't like that it's touching the capacitors.

Citation de "typfred"

Hi!

Have u try to cut a small edge of the screw head? I use plastic screws on my board and had cutted the head a little bit. Therefore the screws are going more straight in the holes and the function is the same. I hope I could help.

I'll look into that - thanks. Trying to rotate it slightly too.