Vous n’êtes pas connecté.
anub1s21
Junior Member


Ce message a été modifié 4 fois. Dernière modification effectuée par "anub1s21" (29 octobre 2026, 05:28)
anub1s21
Junior Member


Take some screenshots where you can see in Aquasuite that the fans aren't working as they should.
In your current screenshot, the fans are doing exactly what's set— 0%.
I dont see any screenshot for this settings.
Citation
SL-INF's these are also on 0% but spinning at 2100rpm
anub1s21
Junior Member


anub1s21
Junior Member


Are the fans connected directly to the Octo, or do you have any cables, adapters, or splitters in between?
he SL-inf's are daisy chained / directly connected to the octo
anub1s21
Junior Member


as soon as the device powers on...aka startup behaviour, it is not following the profile, upon starting my pc i'd say there's a 40% chance of aquasuite at some point pushing the profile through (as i sometimes just go screw it CBA and grab a coffee first and magically when i come back...it applied the profile...or the octo decided now is the time to do what the profile says). other times i see the temp threshold has been reachted, the minimum and fallback fanspeed are suggestions at best, and 2 fan's with 0% output are spinning flat out.
Citation
OCTO Firmware 1021:
QUADRO Firmware 1034:
- Bugfix: Curve controller startup behavior
Ce message a été modifié 8 fois. Dernière modification effectuée par "anub1s21" (4 novembre 2026, 15:13)
das1985
Newbie

Ce message a été modifié 1 fois. Dernière modification effectuée par "das1985" (8 novembre 2026, 07:24)
-